TECHNOR EVFP- LED
EVF-P lighting fixtures are manufactured with an high resistance cylindrical polycarbonate lamp housing and with end cups made of corrosion resistant copper free aluminium.
Polycarbonate lamp housing is a three layers-extrusion UV resistant able to grant the best protection against sun rays and related yellowing effect. Circular shape grants the best possible “CX” factor, therefore it is less affected by winddusts,
no flat surfaces to avoid pollution and dirty bunching. Components and design make EVF-P lighting fixtures suitable for high corrosion environments.
To increase further surface protection, upon request it is possible to apply an OFF-SHORE painting cycle suitable for marine environments. All lighting fixtures are supplied ready for LOOP IN-LOOP OUT facility with 4sqmm cable.

Produktdetails
TECHNICAL FEATURES
Material |
End cups in aluminium with low content of copper / Light housing in polycarbonate |
IP rating |
IP66/IK10 according to EN 62262:2002 |
Ambient temperature range |
-20°C to +55°C |
Approvals |
TÜV CY 17 ATEX 0205846 X |
Marking |
II 2 GD |
Gaskets |
O-ring made of Nitrile Rubber (NBR) |
Surface Treatment |
End cups painted by green colour polyurethane painting cycle RAL6003 (other colour available upon request)
|
Entries |
N° 2 entries M20x1,5. One plugged-off by Ex d brass nickel chrome plated plug and relevant gasket. |
Hardware and screws |
AISI304 Stainless steel external hardware and screws |
Lamps |
Extended long life new LED technology with CRI > 85 |
Ballast |
Electronic |
Rated operation voltage (UE) |
220-240Vac (normal and emergency service)
198-278Vdc (normal service)
|
Frequency |
0/50 Hz - 60 Hz |
Power factor |
> 0,95 |
Accessories available upon request |
AISI304 Pole mounting kit / AISI304 Ceiling / Wall mounting kit / AISI304 Suspension mounting kit / 3° bottom entry M20x1,5 / AISI304 protection guard / Mounting kit in stainless steel AISI316
|